Formatting Instructions for RLDM

	Dorsal S. Raphe	Coauthor
	Department of Computer Science	Affiliation
	Cranberry-Lemon University	Address
	raphe@cs.cranberry-lemon.edu	email

	Coauthor	Coauthor	Coauthor
	Affiliation	Affiliation	Affiliation
	Address	Address	Address	
	email	email	email
			(if needed)

Abstract
The title should be a maximum of 100 characters. 
The abstract should be a maximum of 2000 characters of text, including spaces (no figure is allowed). You will be asked to copy this into a text-only box; and it will appear as such in the conference booklet. Use 11 point type, with a vertical spacing of 12 points.  The word Abstract must be centered, bold, and in point size 12. Two line spaces precede the abstract.

Keywords: 	enter keywords here
Acknowledgements
We are deeply indebted to the Langfeld Fund for their support of RLDM2013. RTF template handmade, to the extent that we could emulate LaTeX. 

1	Submission of papers to RLDM
RLDM requires electronic submissions.  This year's electronic submission site is   
https://cmt.research.microsoft.com/RLDM2013/Default.aspx
Please read the instructions below, and follow them faithfully. Note that there is also a template rldm.tex for LaTeX, which is available from the website below.
1.1 	Style
Papers to be submitted to RLDM must be prepared according to the instructions presented here. Papers consist of a title, which has a maximum of 100 characters, an abstract, which is a maximum of 2000 characters, up to five key words, and an extended abstract, which starts on the second page, and can be between one and four pages, including figures and references. 
The file rldm.pdf contains these instructions and illustrates the various formatting requirements your RLDM paper must satisfy. This is an RTF template which may be used as a “shell” for writing your paper. All you have to do is replace the author, title, abstract, keywords, acknowledgements and text of the paper with your own. Authors preferring LaTeX are requested to use the RLDM LaTeX style files obtainable at the RLDM website at
http://www.rldm.org/
2	General formatting instructions
The paper size for RLDM is “US Letter” (rather than “A4”). Margins are 1.5cm around all sides. Use 11 point type with a vertical spacing of 12 points. Palatino is the preferred typeface throughout. Paragraphs are separated by 6 point space, with no indentation. Section subtitles are separated by 12 point space from the text above and below them.
Paper title is 17 point, initial caps/lower case, bold, centered between 2 horizontal rules. Top rule is 4 points thick and bottom rule is 1 point thick. Allow 0.6cm space above and below title to rules. 
The lead author's name is to be listed first (left-most), and the co-authors' names (if different address) are set to follow. If there is only one co-author, list both author and co-author side by side.
3 	Preparing PostScript or PDF files
Please prepare PostScript or PDF files with paper size “US Letter”.