Mohammed Islam

Professor

Mohammed Islam

Professor

James Maxwell

Mohammed Islam

Professor

University of Michigan
EECS Department
Electrical & Computer Engineering
1110 EECS
Ann Arbor, MI 48109
Tel: (734) 647-9700
Fax: (734) 647-2718
Email:

Additive Manufacturing (3D Printing) Of Plastics & Photopolymers

figure 1

Current experiments utilize a Short-Wave Infrared Super Continuum (SWIR-SC) laser with a wavelength range of 2.0-2.5µm to sinter various thermoplastic powders.  Selective laser sintering is a 3D printing technique that uses a CO2 laser to melt a design into a layer of thermoplastic or metal powder.  A new layer of powder is then rolled out and on top of the previous layer and parts are built up incrementally.  We have verified C-H combinational band absorptions from 2.15-2.5µm in 11 different thermoplastics via FTIR spectroscopy.  Furthermore, we have benchmarked rods created with the SWIR-SC laser against rods created using a CO2 laser, a diode laser, and a 75nm filtered SWIR-SC spectrum.  These rods were found to be 1.5-5x stronger than CO2 created rods.

Future experiments will focus on integrating the SWIR-SC laser with commercial selective laser sintering machines to further benchmark strength of different structures built using this light source.

figure 3
figure 2

Links

"3D Printing of Thermoplastics with Higher Strength Using SWIR-Supercontinuum Laser" (2016)